ST94-21 C/Ku-Band TVRO
Basic Setup of the ACU
4-1
4.
Basic Setup of the ACU
4.1.
Operator Settings
Refer to the Operation chapter of this manual to set the Ship information. Latitude and Longitude should
automatically update when the GPS engine mounted on the antenna pedestal triangulates an accurate location, but
you may enter this information manually to begin. Except when integrating NMEA-0183 Gyro source, you will have to
enter the initial Heading of the ship, subsequently the ACU will then increment/decrement as the Gyro Compass
updates.
Next, set the Satellite information. Longitude of the desired satellite you wish to use and the receiver settings for it are
especially important.
At this point you should be able to target the desired satellite. Continue with the setup steps below to optimize the
parameters for your installation.
4.2.
SETUP Parameter display and entry menus.
Press and hold BOTH the LEFT and the RIGHT arrow keys for 6 seconds to access to the
system setup parameters (at the EL TRIM selection).
Press
BOTH the LEFT and the RIGHT
arrow keys
momentarily
to access to the
SAVE NEW PARAMETERS
parameter.
Access is only required after installation or repairs of your antenna system. These parameters
should only be changed by an authorized service technician.
CAUTION:
Improper setting of these parameters will cause your system to not perform properly. Also refer to the
SETUP section of your Antenna manual.
4.3.
TRACK DISP
This parameter set the selections that the user will see in the Tracking - Band Selection menu. Band Selection must be
set to the appropriate selection for Tracking to operate properly.
Band selection controls the local logic output state of SW1 output terminal on the Terminal Mounting Strip PCB and
remote C/Ku relays (or other switches) on the antenna pedestal.
The factory default selections and SW1 status for your 9797B is listed in the following table:
Setting
Displayed band
selection
ADE Band Select Parameters
(Tone, Voltage & Aux Status)
TMS SW1
Status
0000
C
X
KuLo
KuHi
Tone OFF, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1
Open
Short
Open
Short
When the SW1 output is shorted to ground a current sink of 0.5 amps max is provided to control below
decks band selection tone generators or coax switches. When SW1 output is open it is a floating output.
EAR Controlled - ECCN EAR99
Summary of Contents for ST94-21
