Stowing the Antenna
6012-12W Installation Manual
2.
If not already removed, remove an adjustable
bumper by removing the bottom nut from
one end of the locking bar.
3.
If not already loosened, loosen the top nut
up toward the rubber bumper.
4.
Insert vacant end of the locking bar through
the opening under the cross-level beam.
5.
Insert the adjustable bumper into the vacant
hole on the end of the locking bar.
6.
To restrain the cross-level axis of the
antenna use a 7/16“ open end wrench to
tighten the nut on the top side of the
locking bar until the rubber bumper is
forced up against the bottom of the
cross-level beam.
7.
Verify that the antenna does NOT rotate
(tilt left & right from level).
8.
Re-install and tighten the bottom nut on the
underside of the locking bar.
13.2. Removing the Shipping/Stow Restraints PRIOR to Power-Up
The order the restraints are removed is not critical.
CAUTION:
There are three shipping/stow restraints on this antenna pedestal
that
MUST
be removed,
before energizing
the antenna, for normal operation.
13.2.1.
Removing the AZ Shipping/Stow Restraint
1.
The AZ shipping/stow restraint is
formed by a pin bolt that is lowered into
a channel in a stowage block on the
upper plate of the pedestal (as shown).
2.
To un-stow the antenna, remove the pin
bolt from the LOCK position.
13-5
EAR Controlled - ECCN EAR99
Summary of Contents for 6012-12w
