Sea Tel 6012-12w, Installation Manual

Page: 65 / 130

6012-12W Installation Manual Quick Start Operation
search pattern followed by retarget).
5. Check Latitude, Longitude and Heading.
These should be correct, but may be
updated if necessary.
6. Access the System Status screen.
7. Find the Latitude, Longitude (under Ship)
and Heading (in the banner) displayed
values. If they are correct skip to step 12.
8. If the Latitude & Longitude values are not
correct, access the Communication
Interfaces screen and enter the ships
Latitude & Longitude position in the fields
provided.
9. If the Heading value is not correct, enter the
correct value in the lower right field of the
Communication Interfaces screen. If the
system is set for NMEA or 1:1 type, you will
not be able to enter a heading value.
10. Click Save.
11. Check for blockage (this is the MOST
common cause of not being able to acquire
the desired satellite).
12. Verify that the correct satellite is selected.
13. Check cable connections to assure that a
cable has not been disconnected.
11.3.
If satellite signal is found but network lock is NOT achieved:
1. The Tracking LED will flash for a short
period of time (Search Delay) followed by
the Search LED coming ON.
2. The ICU will automatically move the antenna
in the selected Search pattern until it receives
a signal value that is greater than the
threshold value (red bar in the bar graph). If
signal above Threshold is found, Tracking will
take over (Tracking LED ON) and
automatically peak the antenna position for
highest receive signal level from the satellite
which has been acquired. The system will wait
for the modem to achieve lock. If the modem
does not get lock, the
11-2
EAR Controlled - ECCN EAR99