Sea Tel 14400MK2-21, Operating Instructions Manual

Page: 16 / 107

Installation 14400MK2-21 C/Ku-Band TVRO
3-4
2. Place the radome base frame
on temporary support blocks,
or jack stands, at least 10
inches high.
3. Bolt the eight 6 inch feet to
the under side of the radome
base frame using the
hardware provided. Loosely
assemble all feet before
tightening any of the bolts
and apply Loctite.
Temporarily remove the
support blocks, or jacks, and
set the base frame down on
the assembly surface to align
the feet. Tighten all the
hardware to specified torque.
Raise the base frame back up
onto the support blocks or
jacks.
4. Place the two base pan pieces
on the base frame. Install the
mounting hardware in the
four pan mounting holes.
5. Align the base pan perimeter
holes to the mounting holes
in the base frame.
Note:
You
may want to temporarily
insert bolts in 8-12
equidistant holes around the
perimeter of the base pans to
provide good alignment
throughout the perimeter
hole pattern.
6. Apply Loctite to the mounting
hardware and tighten. If
alignment bolts were inserted
around the perimeter in the
previous step, remove them
now.