Sea Ray 52 Sundancer, Owner'S Manual

Page: 66 / 210

52 Sundancer ® (525 Sundancer ® )
3.12
S
ECTION
3 • U
SING
Y
OUR
B
OAT
T
O
O
PERATE
C
ABLEMASTER
:
1. Open shore power cord
cover.
18. A
NCHORING
To anchor, bring the bow into the wind or current and
put the engine in neutral. When the vessel comes to a
stop, lower the anchor from the bow. The anchor line
should be 5 to 7 times the depth of the water.
A. A
NCHORING
A
RRANGEMENT
The 52 DA is equipped with a windlass and an
anchor chute (see Fig. 3.13.1). Stow the anchor in
the chute when not in use.
NOTE: Before using the anchor, be sure the anchor
safety hook is removed from the anchor and the
anchor is secured to the windlass chain.
17. C
ABLEMASTER TM
W
ITH
R
EMOTE
(A
UTOMATIC
S
HORE
P
OWER
C
ORD
A
DVANCE
/R
ETRIEVE
S
YSTEM
)
Your Sea Ray
®
is equipped with the Cablemaster
TM
shore power cord system located on the transom.
The system will advance and retrieve the shore
power cord as needed to hook up the shore power
system. The Cablemaster
TM circuit breaker is
located on the main DC breaker panel on the
forward engine room bulkhead.
C
ABLEMASTER
(F
IG
. 3.12.1)
(
FIG
. 3.12.2)
(
FIG
. 3.12.3)
CABLE MASTER
IN/OUT SWITCH
(INSIDE LOCKER)
CABLE MASTER
(SHORE POWER CABLE)
2. Press the control switch
to the OUT position to
advance cable to the
shore power hookup, or
the IN position to retrieve
cable for storage. This is
a momentary switch
which returns automatically
to the center OFF
position.
3. For remote operation, leave the regular
Cablemaster switch in the center OFF position.
a. By pressing the buttons on the remote unit,
you will be able to advance and retrieve the
cable. Two (2) points should be observed when
using the Cable-Control system:
• There is a slight delay (less than one (1)
second) between pressing the transmitter
button and operation of the Cablemaster
system. This gives the radio transmitter
and receiver time to establish
communications and for the transmitter to
provide the receiver with the appropriate
instructions.
• When using the Cable-Control Radio
Control system, the regular Cablemaster
switch should be left in the center OFF
position. The regular switch is still fully
operational when the Cable-Control
system is not used.