Sea Ray 52 Sundancer, Owner'S Manual

Page: 114 / 210

52 Sundancer
®
(525 Sundancer
®
)
6.18
S
ECTION
6 • E
LECTRICAL
S
YSTEM
Shore power cord should be secured or routed to
avoid laying or falling into water and to avoid stress
on shore power plug and inlet.
! CAUTION
It is imperative that the shore power outlet is dry
before plugging into the dock power inlet.
! CAUTION
The use of extension shore power cords is not
recommended. Excessive power cord extensions
can cause a voltage drop and may prevent some
electronic devices from operating correctly.
! CAUTION
M
AIN
S
HORE
P
OWER
B
REAKER
B
OXES
(F
IG
. 6.18.1)
240VAC
SHORE MAIN
E. S
HORE
P
OWER
H
OOKUP
(U.S.)
Your 52 DA 240/120 volt AC main distribution panel
distributes the required voltage for all the boat’s AC
equipment and accessories. It is very important to
know and understand where the power originates
and how the power is distributed to the different
voltage equipment and accessories.
To access the shore power cable(s), become
familiar with the instructions in
Section 3 - Using
Your Boat, page 3.12 for “Cablemaster With
Remote,” then follow these steps:
D. M
AIN
S
HORE
P
OWER
B
REAKER
B
OX
The 52 DA is equipped with a 240VAC main shore
power breaker box (Figure 6.18.1). The main
breaker box is located on the aft port side of the
engine room (See figure 4.17.1).
The breaker(s) must be ON at all times to operate
the shore AC power system.
(F
IG
. 6.18.3)
Under no circumstances override the source
select system.
! WARNING
(F
IG
. 6.18.2)
GENERATOR
SHORE
1. Make sure the shore
power breaker and
all AC branch
breakers on the AC
main distribution
panel are OFF.
2. Advance shore
power cord(s) to
dockside power box.
Ensure dockside
breaker is OFF, then
plug the shore power
cord(s) into the
shore power outlet
box on the dock.
Thread the locking ring on the outlet to secure
cable and prevent accidental unplugging.