Sea Ray 390 Sundancer, Owner'S Manual

Page: 168 / 184

8.8
S
ECTION
8 • R
EQUIRED
I
NSPECTION
, S
ERVICE AND
M
AINTENANCE
390 Sundancer ® ( 425 Sundancer ® )
S
EACOCK
(F
IG
. 8.8.1)
OPEN HOSE
HOSE CLAMPS
CLOSED
SEACOCK
HANDLE
SEACOCK BODY
PIVOT POINT
8. S
EACOCK
L
UBRICATION
• With boat out of water, remove the hose from
top of the seacock.
• Put seacock handle in closed position.
• Add a few drops of lubricating oil inside.
• Work handle back and forth a few times. Add
oil as needed.
• Replace hose and tighten clamp.
• Add a few drops of oil to the handle pivot point.
9. E
NGINE
O
IL
C
HANGE
S
YSTEM
A. G
AS
To change the oil in your boat equipped with
standard gas propulsion:
1. Remove oil fill cap. (To allow ventilation)
2. Remove dipstick.
3. Have enough empty containers at hand to hold
all of the used oil.
4. Insert oil pump into dipstick.
5. Pump used oil into empty containers. When all
of the used oil has drained out of the engine(s)
reinsert the oil dipstick and fill engine with fresh
oil through the oil filler cap.
B. D
IESEL
(O
PTIONAL
)
Follow the oil exchange instructions found in Section
4 -
Bilge and Underwater Equipment, page 4.6.
In each case follow the intervals and oil change
instructions provided by the engine manufacturer.
REFER TO THE ENGINE OWNER’S MANUAL
FOR INSTRUCTIONS AND WARRANTY
INFORMATION.
7. S
ECURITY
C
ONSIDERATIONS
Be conscious of the security of your boat.
Always remove the keys from the ignition, lock
hatches, lock the cabin door, remove and stow
any removable electronic gear (fishfinders,
GPS, etc.) and personal gear (fishing poles,
etc.) normally left aboard your boat.
• Clean bilge thoroughly if it was not done at
lay-up.
• Check all engine fluid levels.
• Check fuel lines for damage and/or leaks. Make
sure that they do not come into contact with
moving parts.