52 Sedan Bridge
(525 Sedan Bridge)
2.20
S
ECTION
2 • G
ENERAL
B
OAT
A
RRANGEMENT
B. S
YSTEMS
M
ONITOR
The Systems Monitor consists of a Display Control
Module (DCM) located at the control station and a
Bilge Interface Module (BIM) located on the engine
room component board. The DCM and BIM are
connected to each other by a coax cable and the
BIM is continuously looking at all inputs for an alarm
condition.
The Systems Monitor is connected directly to the
12 volt battery bank through a circuit breaker and
continuously monitors two emergency high water
pumps, two bilge pumps and the bilge heat detector.
The engine and generator functions are only active
when ignition voltage is turned on. The circuit
breaker is on the main DC breaker panel located
on the engine room component board (See Fig.
6.4.1).
The BIM collects signals from critical engine
functions, generator oil pressure, bilge pumps, high
water emergency bilge pumps and bilge heat
detection and transmits that information to be
displayed on the DCM.
The features of the DCM include a two line LCD
display with backlighting of the display, audible
alarm and an Audible Reset/Alarm Select push
button switch.
S
YSTEMS
M
ONITOR
D
ISPLAY
C
ONTROL
M
ONITOR
(DCM)
(F
IG
.2.20.2)
AUDIBLE RESET
SEA RAY BOATS
SYSTEMS MONITOR
SYSTEMS MONITOR
S
MART
C
RAFT
TM
S
YSTEM
V
IEW
(H
OME
S
CREEN
)
(F
IG
. 2.20.1)
• Engine Alarms / Hourmeters
• Engine Synchronizer Display
• GPS Interface
• System Maintenance Records
System View can be fully integrated with the boat’s
GPS, if equipped, to provide up to the minute course,
speed, and fuel-to-destination information.
Note: The detailed information listed which is stan-
dard on some models may be optional on others, or
may not be available on some models based on
engine and system configuration.
Refer to the SmartCraft
TM
System View owner’s
manual in the owner’s packet for all SmartCraft
TM
operating instructions.
S
YSTEM
C
ALIBRATION
(F
OR
F
IRST
T
IME
U
SE
)
When using SmartCraft
TM
System View for the first
time the system must be calibrated before normal
use.
The Sea Ray
®
manufacturer or your Sea Ray
®
dealer has already done this for you. If the system
needs to be recalibrated at some time, refer to the
System Calibration section of the SmartCraft
TM
Sys-
tem View owner’s manual found in the owner’s
packet.
