7
Motormount
Parts for the motormount
include wooden
motormount plate, 2
aluminum L-brackets,
four bolts, 4 washers and
4 knurled nuts.
This rearmost slat has 2 pre-drilled 3/8" holes for
placement of motormount. Bolt the aluminum L-brackets
through these 2 holes by inserting the 2 bolts down
through the front holes in the L-brackets and securing with
knurled nuts below as shown.
Secure the wooden motormount plate to the L-brackets by
running the other 2 bolts through the top holes in the L-
brackets and the 2 holes in the motormount plate itself.
Tighten all knurled nuts and bolts.
Your motormount assembly is now complete.
Fully assembled Deluxe Package looks like this:
Fully assembled FoldCat 375fc Pro Angler’s Package
looks like this:
Please note, after first time assembly of the FoldCat 325fc
or 375fc, for disassembly all you have to do is deflate the
air chambers, remove the underbars, swivel seats,
rodholders, oars and unscrew the oarlocks. For
transportation, simply roll-up the hull along with the
aluminum slats & motormount and place it in the FoldCat
carry bag.
Canopy (for FoldCat 375fc only)
Install 1 Sea Tie on the aluminum step rod in the bow of the
FoldCat 375fc.
Then install the
other 2 Sea Ties to
the last slat in the
stern of the FolCat
as shown.
Install the two
raised oarlock
bases on the sides
of the second wide
aluminum slat from
the bow as shown.
SE 375fc
shown
SE 375fc
shown
