6
Please note, for disassembly it is very easy to detach the
swivel seat or the pedestal from the quick release
seatmount by sliding them out while lifting up the spring
loaded quick release lever mechanism on the swivel seat
mount with your finger as shown below.
Rod Holders
Each rod holder includes the plastic flush mount adapter
and hardware as shown below.
Please note, the Deluxe
Package includes 2 rod
holders and the Pro
Angler’s Package
includes 4 rod holders.
On the 375fc, attach the flush mount adapters for rod
holders at the ends of the 3rd rearmost aluminum slat
and/or the first aluminum slat from the bow. Each of these
ends on the aluminum slats have 1 big 1 1/2" hole & 4 1/8”
holes surrounding the big hole as shown below.
Use four 3/4” screws to attach each flush mount adapter
to the aluminum slat with a phillips head screw driver.
Please note, the adapters can stay attached to the slats
and never need to be disassembled.
Now place the rod holders in the adapters as shown.
For disassembly, you only need to detach the rod holders
from the flush mount adapters.
On the 325fc, install the rod holders at the end of the
middle aluminum slat.
Oar Locks & Oars
There are 2 oars and 2 oarlocks
included in any of our FoldCat
packages. Each oarlock includes a
raised oarlock base, an oarlock pin,
two bolts attached and 2 knurled nuts.
On the 375fc, bolt the raised oarlock
bases at both ends of the 2nd
rearmost aluminum slat through the 4
pre-drilled 3/8" holes (2 at each end)
using knurled nuts. And then place
the oarlock pins into the raised
oarlock rods as shown.
Now snap the two 8’ sectional oars together and inset each
oar into the oarlock pins and tighten the wingnuts to secure
the oars as shown below.
On the 325fc, the raised oarlock bases are installed on the
first aluminum slat in the bow. And then attach the oarlock
pins and oars as explained above for 375fc.
