10
FastCat | ASSEMBLY & INFLATION
Fold the canvas in half so
the shiny side is facing out
and the bars are lying on
top of each other.
Insert the side rods into the
curved bars until the
locking pins engage
through the holes.
Place the canopy on the
back of the boat with the
short bars up.
Use the short screw and
the knob to secure the rods
to the black canopy pads
on the boat.
Attach the rear clips to the
small D-rings behind
transom. Attach front straps
behind the front carry
handles. Adjust and tighten
straps by sliding the
buckles.
Canopy can be folded
towards the back of the
boat. Some rod holders
may have to be turned for
the canopy to clear them.
Scotty® Deck Mounts
(OPTIONAL):
Attach deck mounts with
7/8” phil cap screws
provided to the pad
mounts near the transom.
Screws are located in
Orange Repair Kit.
Arrow points inboard.
Don’t stab the pad!
Use
only
¼ - 20 x 7/8” screws
provided in the orange repair
kit. Longer screws, pointed
screws, etc., will puncture the
air chamber.
Puncturing the air chamber in
this manner is not covered under
the warranty.
Caution:
Puncture
hazard: do not thread screws
into base without the Scotty
Deck Mount.
To install a Scotty accessory
in the mount, push stem into
base until it clicks in.
Shown here is the Scotty®
Baitcaster Rod Holder.
Anchor Lock mount does not
have button, it works by lining
up a groove in the stem with a
raised key in the base. Lift
partially and turn Anchor Lock
to swing anchor overboard.
Large knob on side of Rod
Holder is for adjusting rod
angle.
