11
FastCat | ASSEMBLY & INFLATION
FastCat | DEFLATION
Remove transom,
crossbenches, rod holders,
and canopy. Rod holder
bases remain in place.
Place the boat bag under
front of boat. Place bag so
bottom panel is even with
front end of boat and bag
is 6 - 8” off center. Push air
out.
To deflate, push down on
the valve stem and quarter
turn it to the right. The
stem will stay in the down
position, allowing the air
to escape.
Caution:
Air escapes
with force, do not place
face directly over valve.
Attach Scotty rod mounts
to the aluminum
crossbenches with #6 x 1”
truss head screws.
This one-time installation
is easier done with a power
drill with #2 phillips head
tip. Leave the screws loose
until the last hole then
tighten all the screws.
As boat deflates push it to
one side. Push it so that it is
even more off center of the
bag. Push more air out.
FastCat | DEFLATION
Fold one side onto the
other so it falls centered on
the bag. Push more air out.
Lift the back end of the
boat so it folds between rod
holder base and crossbench
D-rings. Push more air out.
Lift the last section onto
the front. Push remaining
air out.
Pull the bag end flaps
onto bag and run the staps
thorough both metal rings.
Then run the strap between
the rings and pull tight.
