8
FastCat | ASSEMBLY & INFLATION
Lay one end of bench over
the screws, so screws come
up through the holes in
bench.
Locate seat hold down D-rings
which are attached to sides of
boat. Insert M6 x 50 screw with
washer through each ring and
fold ring flat with bolt
pointing upward.
D-rings must be folded
towards each other.
Partially thread bench
knobs onto bolts. Leave
theses loose until bolts are
inserted through
opposite end of bench.
Push bench down against
boat with one hand and
tighten each knob.
Place one washer and one
nut on each screw. Tighten
screw with #2 philips head
screwdriver and a 7/16” or
adjustable wrench. Screw
must engage the nylon
insert in the locking nut.
Locate the hardware for
the seat mount:
4 - 1 ¼” Phil Flat screws
4 - 1” flat washers
4 - Nylock nuts
Insert screws through the
holes in the seat mount.
Place seat mount over the
holes in the crossbench.
Slide seat onto seat release.
When seat is fully pushed
into seat release, the
locking mechanism will
pop down with a click.
Locate aluminum cross
bench(es), quick
disconnect seat mount (s),
seat(s) and hardware.
Hardware per bench
4 - M6 x 50 screws
4 - 5/16” x 1¼” washers
4 - knobs
