MAINTENANCE PROCEDURES
– Clean terminals and connectors if
necessary.
– For storage, pull battery or discon-
nect battery cables.
Ignition Coils
Ignition Coil Removal
1. To access the ignition coils, remove
the central body. Refer to
CENTRAL
BODY REMOVAL
section.
NOTICE
Do not remove the igni-
tion coil before disconnecting the
input connector or the wires may be
damaged. Do not pry up ignition coil
with a screwdriver to avoid damage.
2. Disconnect ignition coil connector.
3. Remove
ignition
coil
retaining
screw.
4. Remove ignition coil from spark plug
by rotating coils side to side as you
pull up.
smr2014-032-001_a
1. Ignition coils
Ignition Coil Installation
1. Align the retaining screw hole of the
ignition coil with the threaded hole
on the valve cover.
2. Install the ignition coil on the spark
plug and push it all the way down
until it rests on the valve cover.
3. Install the retaining screw and
tighten to specification below.
IGNITION COIL RETAINING SCREW
Tightening torque
11 N•m (97 lbf•
in
)
4. Connect ignition coil connector.
Spark Plugs
Spark Plug Removal
1. Disconnect the ignition coil input
connector.
2. Remove ignition coil. Refer to
IGNI-
TION COIL REMOVAL
.
WARNING
Never remove an ignition coil from
a spark plug without disconnect-
ing it from the wiring harness.
Flammable vapors may be present
in the bilge. Should the tether cord
be installed on the engine cut-off
switch, a spark could be generated
at the coil spark plug end which
could cause an explosion.
3. Using a spark plug socket, release
the torque applied to the spark plug.
A00
E
0BA
2
1
1. Approved socket
2. Improper socket
4. Clean the spark plug and cylinder
head with pressurized air.
5. Unscrew spark plug then use the
ignition coil to take spark plug out of
spark plug hole.
90
______________
Summary of Contents for 2014 Spark Series
