SDLG LG6210E, Maintenance Manual

Page: 150 / 782

Maintenance Manual
──LG6210E
Hydraulic Excavator
132
5 Tighten screw on the filter by hand until the seal contacts
tightly, then turn a half circle.
6 Perform to exhaust air. Refer to fuel system, oil leakage
Additional extra oil filter, replacing
Tool
9996671 oil filter wrench
11666167 Removal Tool
Note! Fuel filter is clogged, which may cause engine power
reduced. If the filter is clogged quickly, check fuel for
contamination, if necessary, clean the tank.
1 Turn the main pump (1) counter clockwise, making the
plunger unlocked.
2 Disconnect the cable connector (1).
3 Loosen the drain valve (2), and drain the sediment from
the oil-water separator tank (3).
4 Use an 9996671 oil filter wrench to loosen oil-water
separator tank (3), then remove it.
5 Use a 11666167removal tool to release oil-water
separator filter, and then remove it.
6 Clean the sealing surface of filter head
7 Coat the rubber seal on the new filter with a little oil, or
wet with diesel fuel.
8 Tighten screw on the filter by hand until the seal contacts
tightly, then turn a half circle.
9.Tighten the filter tank by hand until the seal contacts
tightly, then turn a half circle.
10 Perform to exhaust air. Refer to fuel system, oil leakage
Fig. 37
1 Main pump
Fig. 38
1 Wiring harness connector
2 Drain valve
3 Oil Bowl