- 43 -
8) Scatter shield pipe mounting (GF)
①
Emitter/Receiver
②
Scatter Shield
③
T-bolt-M6×14.5
④
M6 hexagon nut, Φ6 elastic/plain washer
⑤
T-bolt-M6×24
⑥
M5×25 inner hexagon screw, Φ5 elastic washer
⑦
M5 square nut
⑧
Q-clamp
1. Install the adjustable pipe-mounting support
● Select proper position from two sides of machine, drill and tap according to dimensions shown in
Fig2.15.A. Fix the bracket seat onto the machine bed piece by two M8×20 inner hexagon screws.
● Fix the bracket arm on the bracket seat by one M16×45 hexagon screw.
● Insert steel pipe into the round hole of bracket arm, adjust it to a proper height, tight properly the M8×25
inner hexagon screw.
2. The emitter and receiver are fixed on the T-slot inside the scatter Shield by ZC-mounting bracket, upper
and lower shock absorbers, and T-bolt.
3. Fix the Q-clamp onto Scatter Shield through T-bolt-M6×24 and M6 hexagon nut.
4. Fix the emitter Scatter Shield on the double-arm pipe through Q-clamp, adjust the height of emitter to
the requirements of the position, tight properly the tightening screws on the Q-clamp.
5. Fix the receiver Scatter Shield on the double-arm pipe through Q-clamp, adjust the height of the
receiver with the emitter at the same height, tight properly the tightening screws on the Q-clamp.
6. Adjust the position of emitter and receiver, including safety distance, relative altitude height and
feathering angle, make them parallel, corresponding, aligned.
7. Fasten all mounting screws after start-up test.
Fig 2.15 Scatter shield pipe mounting (GF)
Fig 2.15.A
Fig 2.15.B
