P:\INST INSTRUCTIONS\EXIT DEVICES\INST-S6200 Rev A 04-22 Page 6
STEP 4: INSTALL TOP ROD AND TOP STRIKE
1. Mount the top latch assembly into the mounting bracket (see figure 7).
2. Screw the threaded end of the top rod onto the top latch assembly completely (see figure 8).
Threaded end of
top rod
Figure 7
Figure 8
3. Measure and cut the length of the top rod. The length of the top rod is measured to the edge of
the rod connector (see figure 9) which will be attached to the chassis.
4. Insert the rod connector into the non-threaded end of the top rod and secure in place by
tightening the locking screw (see figure 10).
5. With the top rod connector installed, attach the top rod to the chassis at the location indicated
by the arrow (see figure 11).
Edge of rod
connector
Mark cutting line and
cut top rod
Figure 9
Non-threaded
end of top rod
Locking
screw
Figure 10
Figure 11
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: [email protected] ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
