P:\INST INSTRUCTIONS\EXIT DEVICES\INST-S6200 Rev A 04-22 Page 5
STEP 3: INSTALL BOTTOM ROD AND BOTTOM STRIKE
1. Mount the bottom latch assembly into the mounting bracket (see figure 3).
2. Screw the threaded end of the bottom rod onto the bottom latch assembly (see figure 4).
3. Using the supplied screw, attach and fasten the bottom rod to the chassis at the location
indicated by the arrow in figure 5.
NOTE: If the hole on the bottom shaft connector does not align with the mounting hole in
the chassis, adjust the length by turning the rod in or out of the latch assembly.
4. Install bottom strike into finished floor or threshold, and be sure to align center line of bottom
latch with the centerline of the bottom strike (see figure 6)
5. Depress and release push bar to confirm proper operation.
a. Verify that the bottom latch can be retracted and flush with the edge of the door when push bar is depressed.
b. Confirm that the bottom latch bolt has at least 19/32" of minimum throw when push bar is released.
Figure 3
Threaded end of
Bottom rod
Figure 4
1/4”
2-1/4”
7/8”
2-3/32”
L
C
Figure 6
Figure 5
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: [email protected] ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
