FR
::: 4
FR
::: 5
CONTENTS
FuNCTION
GENERAL INFORMATION
● 1 transmitter
● 1 receiver socket with 16A/3680W IP44
● 1 battery: type 12V, 23A (included for transmitter)
Please read this instruction manual carefully before using
and keep this manual during warranty limit.
With this product you can switch electrical devices under
the max. capacity 16A/3680W within a range of up to
25m (without obstacles). The transmitter only works if the
device is turned on. (see
picture 1
)
● Do not connect more receivers after each other.
● The distance between two working sockets should be
more than 50 cm.
● For outdoor using with IP44, at temperatures between
0°C-35°C.
● Only to be used in wall-mounted sockets, do not
connect to an extension cord.
● Don’t connect to appliances which should always be
under surveillance, because these could cause fire or
other damage, like a flat-iron or frying pan.
● Don’t open the device. Only a professional person can
carry out repairs. Misuse and unprofessional repairs can
cause electric shock or short-circuit.
● Range is about 25m (without obstacles); this distance
can be seriously influenced by concrete walls,
electronic or electro-magnetic interference from
fluorescent lamps, cordless phones, headphones,
TV, electric wiring, etc. If possible, remove disturbing
appliances.
OPERATING
Make sure the remote control works perfectly by
pressing the buttons. The red indicator lights.
Now the system code of the transmitter must be set by
putting the switches 1 to 5 in the desired code, to avoid
that the remote control interferes with other transmitters
or even with the neighbors’. System codes must be
different, for instance if you put switches 1, 3 and 5 in
ON-position, the system code is 1 3 5. If the switches are
on 2 and 4, the system code is 24 (
picture 2
).
Remote socket:
unscrew the cover on the back of the
receiver socket. Put the white switches 1 to 5 in the same
position as the transmitter (see below).
picture 2
picture 3
Then, set dip switch n°6 in ON position. Pay attention all DIP
SWITCH from 7 to 10 in OFF position
● Max. capacity: 16A/3680W for each receiver
● IP44
● Voltage: 230V~/50Hz
● Frequency: 433,92 MHz
● Remote control battery: Type 12V, 23A
● Range: about 25M (without obstacles)
TECHNICAL DATA
Setting
(A-E, CODE 1-10)
Transmitter :
for the remote control a 12 V battery is used.
Remove the cover on the back side of the remote control
(
picture 1
) and insert the battery. Please pay attention to
the symbols indicating the battery positioning.
picture 1
IMPORTANT :
the transmitter and the receiver socket
are already pre-set for the radio transmission
