9
this will cause severe damages to the product and this operation will invalidate
the warranty.
-
Lower down the winch till half stroke, pressing the remote control button
▼
and stop it
with button
.
- Press the button
(for 5 secs) till the motor swivels 2 times.
- Press again the button
(for 5 sec) till the motor swivels 4 times.
- Press the button
▲
(for 5 sec) till the motor swivels 2 times.
- Press the buttons
▼
or
▲
in order to the reach the desired position of the winch.
Warning: during this programming operation you have to keep the buttons
▼
or
▲
pressed in order to reach the desired position.
- Once this position is reached, in order to memorize it press the button
(for 5 sec) till
the motor swivels 3 times.
In case of mistake, repeat the procedure.
C- USE OF THE REMOTE CONTROL
-
Press the button
▼
in order to reach the lower-end stop.
-
Press the button
▲
in order to reach the upper-end stop.
D – CONNECTION OF LOW VOLTAGE CONTACTS TO REACH THE DIFFERENT
END-STOPS
-
Close the connection, for at least 1 second, between the white-black and white-
orange wires in order to reach the LOWER end stop.
-
Close the connection, for at least 1 second, between the white-black and white wires
in order to reach the UPPER end stop.
DO NOT TRY TO HIGH UPPER END-STOP, OTHERWISE THE SCREEN WINCH
SYSTEM CAN BE DAMAGED PERMANENTLY AND THE WARRANTY WILL BE
VOIDED.
WARNING: do not change the end stops of the projection screen, otherwise you will
invalidate
the
warranty
on
the
screen.
Fig. 7A
