6
6. At the bottom side of the beam you have to mount the remaining 3 brackets (see Fig. 5).
Take care that the left bracket has to be mounted at 20 cm. from the left end side of the
beam and the right racket has to be mounted at 20 cm. from the right hand side of the beam.
Now fix the screen housing at these brackets taking care that the power cable of the screen
is at the right side of the housing.
Fig. 5
7. With the winch completely rolled up, you have to adjust the screws fixed on the L-form
brackets, which are fixed on the beam (see fig. 6) so that the beam is perfectly horizontal
and check also that the steel cables from the winch to the beam are perfectly in vertical
position. In case the steel cables are not perfectly vertical, please move the metal ring on
the beam, left or right in order to position the steel cable vertically. In case you have moved
the
eyebolt,
check
carefully
that
you
fix
it
again
sturdy
to
the
beam.
8. To connect the mains 220V to the screen, you have to use the cable coiler that is included
in the packaging. Mount the cable coiler to the ceiling behind the screen winch housing at
the right side (see Fig. 6B), using suitable screw anchors (
fixings are not supplied
).
Fig. 6B
– CABLE COILER
9. Now fix at the rear side of the beam the L form bracket as indicated in Fig. 7 and fit the
output power cable of the screen winch through the bracket and fix it with two wire clamps
as shown in Fig.7 in order that it remains fixed when the beam moves up and down.
Fig. 5
Fig. 6
