ZAA2300 ManualZAA2300 Manual
23. September 2021
© Copyright 2021, PROCEQ SA
35
8.2 Lubrication of the guide rods
From time to time it can be necessary to lubricate the guide rods with some sewing machine
oil or something similar.
Before lubricating the guide rods of the ZAA 2300, always switch off the apparatus and
unplug it.
No oil shall be sprayed into the apparatus. The function of electrical or mechanical
components could be impaired.
For lubricating proceed as follows:
Remove the inserted plate (see also chapter 6
on page 27).
Turn the apparatus carefully on one side so that the side opening of the cover becomes
accessible.
Put some drops of sewing machine oil on your finger and spread it over the whole length
of the guide rods.
Repeat this for the other side of the apparatus.
Adjust the start stop (1) at the very beginning and the end stop (2) at the very end and
move the drawing unit (22) back and forth several times, so that the oil gets distributed
evenly over the whole length of the rods.
Insert the required plate.
8.3 Replacing the fuse
If the apparatus cannot be switched on (operation light POWER (15) is not glowing, this
could be due to a defect fuse. You can replace the fuse by yourself by opening the fuse
holder (18) on the back of the apparatus between the main switch (16) and the power supply
socket (17) carefully using a screw driver or a similar tool.
Before replacing the fuse, always switch off the apparatus and unplug it.
Replace the fine fuse (18) only by an equivalent fuse of the same type with the
same specification.
Make sure that the inscription at the connection caps of the fuse
corresponds to one of the following designations:
T 0.8 A / 250 V
T 800 mA / 250 V
T 800 / 250 V.
Clamp the new fuse into the fuse holder (18) and put it back in its place.
Should it still be impossible to switch on the apparatus, please contact
Proceq SA
or your
authorised partner.