11
SECTION 6. Lockers
(cont.)
Setting and Attaching Lockers in an Island:
When building an island begin joining your first set of banks back to back (see figure on left below). Pre-
drill
3/16
” holes approximately 3” down and 3” over in the four corners of the bank. Securely fasten us-
ing
3/4" stainless steel torx head screws
provided. Lockers should sit flush and level.
Locate the next bank required. Place this bank into position next to the first bank installed (see figure on
right below). Locate the pre-drilled holes on the side of the face frame. Join the second bank to the first
bank using the 10-24 x 1” thru bolts provided. Do no overtighten the screws.
Continue to set each bank into place, side to side and then back to back, keeping the lockers level. If ba-
ses are provided, secure lockers to the base using 1-1/2” torx head fasteners (T-27). If bases are not
pro-vided, attach lockers to the floor using
3/4" stainless steel torx head screws
provided.
Note:
Stretching and compressing lockers is a sign of overtightening thru bolts which will prevent proper
functioning of lockers.