User Manual for the
SCE275
Table of Contents
Introduction
. . . . . . . . . . . . . . . . page 3
Warranty . . . . . . . . . . . . . . . . . . page 3
Installation . . . . . . . . . . . . . . . . . page 3
Location & Assembly . . . . . . . . . . . . page 3
Plumbing . . . . . . . . . . . . . . . . . . page 5
Electrical . . . . . . . . . . . . . . . . . . page 5
Final Check List. . . . . . . . . . . . . . . page 6
Initial Start Up . . . . . . . . . . . . . . . page 6
Removal of the Cabinet . . . . . . . . . . . page 7
Maintenance. . . . . . . . . . . . . . . . . page 9
Failure Analysis . . . . . . . . . . . . . . . page 9
Introduction
This manual contains the information needed for the set
up, installation, initial start up, sanitation and
maintenance this product.
The SCE275 is an ice machine that produces cubed ice
on a vertical freezing surface. The cubes fall into the ice
storage bin where they break up into individual cubes.
The ice machine automatically maintains the level of ice
by switching on when the ice level falls, and switching
off when the bin is full.
This unit is serviceable in place; the ice storage bin and
hood may be removed from the chassis to allow service
access without removing the ice machine from its
installed position.
Warranty
The warranty conditions are those supplied by the
official distributor for your area. In case of parts, only
genuine service parts may be used.
Installation Limitations
The unit is equipped with an electrical power cord, but
should only be plugged into a circuit dedicated to the ice
machine.
The ice machine must be installed indoors in a controlled
environment.
Minimum
Maximum
Air Temp
50
0
F.
100
0
F.
Water Temp
40
0
F.
100
0
F.
Water Pressure
20 PSI
80 PSI
Voltage (50 Hz)
207
253
Operating the ice machine outside of the above
limitations, or outdoors, is potentially damaging and is
misuse of the machine. This may void the warranty.
Scotsman Ice Systems are designed and manufactured
with the highest regard for safety and performance.
Scotsman assumes no liability or responsibility of any
kind for products manufactured by Scotsman that have
been altered in any way, including the use of any part
and/or other components not specifically approved by
Scotsman.
Scotsman reserves the right to make design changes
and/or improvements at any time.
Specifications and design are subject to change without
notice.
Location and Assembly
Airflow on air cooled models is: Intake through the left
front grill. Exhaust through the right front grill.
Do not install where this air flow is obstructed.
The SCE275 has a removable cabinet. When installed,
the machine should have some extra clearance (1/8") on
the left and right sides so that the cabinet may be easily
removed when the machine is in place.
Installation
This ice machine may be installed in the open or under a
counter. No clearance is required at the sides or top
beyond what’s needed to place the cabinet into position.
Air cooled models blow air in and out through the grills
at the front. Space is required for utility connections at
the back.
3
