Page 24
Page 24
REMOVAL AND REPLACEMENT PROCEDURES
WARNING - Disconnect electric power
supply to icemaker whenever replacement
procedure are performed.
WATER PUMP
1. Remove front panel.
2. Remove the control box cover.
3. Unplug pump from P.C. Board.
4. Remove screws holding pump bracket to the
right side of freezing compartment.
5. Pull pump forward and lift up.
6. Remove discharge hose from pump outlet.
Reverse to replace.
RESERVOIR
1. Close water valve on water supply line.
2. Remove front panel.
3. Remove evaporator front cover.
4. Remove reservoir drain plug and flush
reservoir out.
5. Remove screws securing reservoir.
6. Lift-up and pull forward to remove reservoir.
Reverse to replace.
DISTRIBUTOR/WATER TUBE
1. Remove front panel.
2. Remove evaporator front cover.
3. Locate water distributor at the top of the
evaporator.
4. Pull distributor forward to unsnap it from its
holdind clamps.
5. Remove hose clamp and water hose.
Reverse to replace.
OUTLET WATER VALVE
1. Remove front and right side panel.
2. Remove fan motor shroud.
3. Unplug water valve.
4. Remove clamp securing outlet tube to valve.
5. Remove hose clamp and hose from inlet
fitting.
6. Remove two screws and nuts securing valve
to its metal bracket and remove valve.
Reverse to replace.
COMPRESSOR
1. Remove top panel (if possible), front panel,
left side service panel and left fan motor
shroud.
2. Store refrigerant charge in liquid receiver.
3. Disconnect electrical lines from compressor.
4. Isolate parts to be opened from rest of the
system.
5. Remove compressor mounting bolts.
Reverse to reassemble.
CONDENSER - AIR COOLED
1. Remove both side panels and remove screws
of condenser bracket.
2. Store most of refrigerant charge in liquid
receiver.
3. Isolate parts to be opened from the rest of the
system.
4. Cut or unsweat liquid and discharge lines.
5. Unbolt and remove condenser from unit re-
ar side.
Reverse to reassemble.
CONDENSER - WATER COOLED
1. Shut-off water.
2. Remove front and left side panels.
3. Store most of refrigerant charge in liquid
receiver.
4. Isolate parts to be opened from the rest of the
system.
5. Unsweat water and refrigerant lines.
6. Unbolt and remove condenser.
Reverse to reassemble.
HOT GAS VALVE
1. Remove front, right side panel and right fan
motor shroud.
2. Unplug hot gas valve.
3. Purge system of refrigerant.
4. Cut or unsweat valve, remove from machine.
5. To replace, heat sinking the valve is CRITI-
CAL. Wrap the replacement valve in wet
rags, and sweat into place. Leave rags on
until joints cool.
Reverse steps 3-1 to reassemble.
WARNING - Be sure the electrical power
supply circuit breaker and the inlet water
supply are OFF, BEFORE starting any of
the folloving REMOVAL AND REPLACE-
MENT procedures as a precaution to
prevent possible personal injury or
damage to equipment.
REMOVAL AND REPLACEMENT OF THE
DRIER
To remove the drier:
1. Remove front and left side panel.
2. Remove screws and remove left side fan
motor shroud.
3. Store most of the refrigerant charge into liquid
receiver.
4. Unsolder refrigeration lines at both ends of
the drier and remove the drier.
To replace the drier.
