Location:
While the machine will operate satisfactorily within
the listed air and water temperature limits, it will
produce more ice when those temperatures are
nearer the lower limits. Avoid locations that are hot,
dusty, greasy or confined. Air cooled models need
plenty of room air to breathe. Air cooled models
must have at least six inches of space at the back
for air discharge; however, more space will allow
better performance.
Airflow
Air flows into the front of the cabinet and out the
back. The air filters are on the outside of the front
panel and are easily removed for cleaning.
Options
Side air flow kits
KPFSA223
or
KPFSA227
are
available for air cooled models. A filter kit for the
remote condenser is KERCF
Ice is made until it fills the bin enough to block an
infrared light beam inside the base of the machine.
A field installed kit is available to adjust the
maintained ice level lower. The kit number is
KVS
.
The standard controller has excellent diagnostic
capabilities and communicates to the user through
the AutoAlert light panel, seen through the front
panel. Field installed kits are available that can log
data and provide additional information when the
front panel is removed. The kit numbers are
KSBU
and
KSB-NU
. See page 21.
Bin compatibility
All models have the same footprint: 22 inches wide
by 24 inches deep. Confirm available space when
replacing a prior model.
Bin & adapter list:
•
B222S or B322S – no adapter needed
•
B330P or B530P or B530S – Use KBT27
•
B842S – KBT39
•
B948S – KBT38 for single unit
•
B948S – KBT38-2X for two units side by side
•
BH1100, BH1300 and BH1600 upright bins
include filler panels to accommodate a 22
inch wide ice machine. No adapter is
needed.
BH900: Use baffle kit KBBF1 for these models.
Dispenser compatibility
Only
nugget
ice models may be used with ice
dispensers. Flaked ice is not dispensable.
•
ID150 – use KBT42 and KDIL-PN-150,
includes KVS, KNUGDIV and R629088514
•
ID200 – use KBT43 and KNUGDIV and KVS
•
ID250 – use KBT43 and KNUGDIV and KVS
See sales literature for other brand model ice and
beverage dispenser applications.
Other Bins & Applications:
Note the drop zone and ultrasonic sensor locations
in the illustrations on the next pages.
Scotsman ice systems are designed and
manufactured with the highest regard for safety
and performance. Scotsman assumes no liability of
responsibility of any kind for products
manufactured by Scotsman that have been altered
in any way, including the use of any part and/or
other components not specifically approved by
Scotsman.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.
July 2009
Page 3
N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
Air, Water or Remote User Manual
Airflow
