Scooter Fly 50 4t 4v, Workshop Manual

Page: 85 / 208

- If the above tests have positive results, jump con-
tacts 5 (blue/black) and 3 (white) on the connector,
set the key switch to ON and turn the turn indicator
switch to the left and right to see when the lights
are steadily on (as they are directly powered by the
battery).
If even after this operation the turn indicators fail
to turn on, check that the wiring is not damaged
and the switch works properly. If these last two
tests have a positive result, replace the regulator
because it is certainly not functioning properly.
Specific tooling
020331Y Digital multimeter
Dry-charge battery
Where provided
WARNING
BATTERY ELECTROLYTE IS TOXIC AND IT MAY CAUSE SERIOUS BURNS. IT CONTAINS SUL-
PHURIC ACID. AVOID CONTACT WITH YOUR EYES, SKIN AND CLOTHING. IN CASE OF CON-
TACT WITH YOUR EYES OR SKIN, RINSE WITH ABUNDANT WATER FOR ABOUT 15 MINUTES
AND SEEK IMMEDIATE MEDICAL ATTENTION.
IN THE EVENT OF ACCIDENTAL INGESTION OF THE LIQUID, IMMEDIATELY DRINK LARGE
QUANTITIES OF WATER OR MILK. MAGNESIUM MILK, BATTERED EGG OR VEGETABLE OIL.
SEEK IMMEDIATE MEDICAL ATTENTION.
BATTERIES PRODUCE EXPLOSIVE GASES; KEEP CLEAR OF NAKED FLAMES, SPARKS OR
CIGARETTES; VENTILATE THE AREA WHEN RECHARGING INDOORS.
ALWAYS PROTECT YOUR EYES WHEN WORKING CLOSE TO BATTERIES.
KEEP OUT OF THE REACH OF CHILDREN
Commissioning dry-charged batteries:
1) - Remove the short closed tube and the plugs,
then pour sulphuric acid into the cells using the
type specified for batteries with a specific gravity
of 1.26, corresponding to 30 Bé at a minimum tem-
perature of 15°C. until the upper level is reached.
2) - Leave to rest for at least 2 hours; then, restore
the level with sulphuric acid.
3) - Within the following 24 hours, recharge using
the specific battery charger (single) or (multiple) at
a density of about 1/10 of the battery nominal ca-
pacity until fully charged; check that the acid den-
Fly 50 4t 4v
Electrical system
ELE SYS - 85