4
Status keeping indicator:
Under program control mode, when the equipment is in the state of temperature keeping,
this indicator will be light.
Refrigeration indicator:
When the refrigerating system is working, this indicator will be on.
4.Preparation and Start-up
n and
1.After the equipment is positioned according to the points for attention, press down the
pressing board on the castor to fix so as to avoid any move when using.
2.Configuration of power supply of AC 220~240V 50/60Hz with capacity not less than the
power required in the specification. Use a dedicated jack socket for this equipment.
3.Connect the plug of power supply of the equipment with an independent jack socket.
4.Turn on the master switch on the right side of the equipment, power is applied to the
unit, the five digital tube displays the following in turn: PHTC3, Time, Real temperature.
Then the equipment is in the state of readiness.
5.Setting of the control mode
This equipment has two operating mode, i.e. constant temperature control and programme
control, users can choose one according to their need.
Hold on the “Change/Confirm” button for 3 seconds, the screen displays “CIP”and a second
la
ter “0”, press the “Increase” button to input the password “1”, then press the “Change/Confirm”
button, the screen will display the original control mode: “Ctr=”means constant temperature
control, “CtrP”means programme control. Press the “Decrease” or “Increase”button to change
the control mode. Press the “Change/Confirm” button to confirm the change.
Attention:
Press the “Change/Confirm” button to display time. When in setting operation, If
the button is left untouched for 3 minutes, the screen will automatically switch to
display the real temperature.
HOLD
COLD
Attention!
Only use a properly grounded outlet, verify the local voltage of power
supply before start, we are not responsible for damages caused by
incorrect voltage of power supply.
PHTC3
25.1
10.25
