Other:
-Rain / Water proof
-Built in strainer and Bypass Valve
-Explosion proof permanent magnet motor
-Thermal Overload protection
Installation & Usage
1)
Tightly screw in suction pipe or dip tube (not supplied) into the 1” inlet using teflon
tape. Your inlet tube or dip tube should terminate ~3” from the bottom of the drum or
container.
2) Securely attach the 4 meter discharge hose (supplied) to the outlet. Use Teflon
tape.
3) Connect your 12V power supply by removing the electrical junction box cover and
connecting you power leads (Black -ve, Red +ve). Using an M20 (not supplied)
cable gland seal the power cables as they leave the rear of the pump.
4) Pump body should be earthed as per the instructions on the pump label.
5) The pump is turned On or OFF with the Upper and Lower levers. Move the Upper
Lever to ON.
6) Keep the nozzle in contact with the drum being filled.
Warning:
1) The drum or container being filled should be earthed to prevent static discharge and
possible fire or explosion. The discharge hose is not conductive and does not
provide an earth.
2) Do not install additional foot valves or check valves that do not have a pressure
relief valve.
Trouble Shooting
Q) The pump is working but is not delivering appropriate flow rate or flow rate is
decreasing.
A) Possible hose or filter blockage or air leaks. Check all hoses and connections. Also
check pump positioning, clean pump and check vanes are sliding easily.
Q) Pump fails to prime.
A) Check for air leaks in suction tube. Check bypass valve for grit or dirt.
Q) Motor hums or fails to start.
A) Pump motor may be bound. Remove cover and check rotor and vanes for dirt and
make sure movement is free.
Summary of Contents for SPEP12V75
Page 6: ......
