Copyright (c) Scintex www.scintex.com.au [email protected]
Page 9
STEP 7 - Mounting the Pump
Bolt the pump onto the frame using 4x bolts, washers and nuts. The pump inlet should be
closest to the Valve Plate. See Image 13.
Image 13
NOTE:
It is recommended all bolts are checked for tightness on a regular basis. In some
circumstances a small amount of lock tight may be required to ensure maintain a firm
mounting.
STEP 8 - Install Remaining Fittings
1) Screw the 2x hose tail fittings into the pump inlet / outlet. See Image 14.
2) Install the 2x fitting sets to the top and bottom of the filter house. Note: The filter housing
legs can be extended to allow room for the fittings. See Image 15 & 16.
