TS-1084
Replacing the X-axis
Idler Pulley
Document Owner:
Service Department
Effective Date:
AUG-23-2022
Page 2 of 4
5. Loosen the two bracket screws using a 4mm allen wrench to allow the tensioner to
move, as shown in Figure 2 below.
Figure 2.
6. Loosen the X-axis tension screw by using a 3mm allen wrench to relieve belt tension on
pulley, shown in FIgure 3 below.
Do not remove the screw, only loosen it
.
Figure 3.
File Location: DMS
Revision A Approved Date: AUG-22-2023 Approved by: Service
