SCIFIT ISO7000R, Service Manual, Page: 44 / 82

44
•
When looking at the back of the upper PCB, the Telco cables plug in
along the left edge. The 6-pin plugs into the top plug and the 8-pin
plugs into the bottom plug.
•
If your unit has Cardio Key, the cable plugs into the serial port, which is
the 4-pin Molex header lower right corner.
•
If your unit has Broadcast Vision, Cardio Theater, etc., the cable
connects to the 8-pin header located at the bottom center of the upper
PCB.
11. Place the console assembly back onto the mounting plate and install the
four (4) display mounting screws.
L. Contact Heart Rate PCB Replacement
(Use this procedure for
ISO7000R’s with serial numbers 570-005257 thru 570-005295.)
1. Using a Philips screwdriver, remove the four (4) display mounting screws
on the back of the display mounting plate.
2. Remove the two (2) outer countersunk screws in the back of the plastic
console (A1537), using a Philips screwdriver. This will free the upper PCB