www.science-image.com
7/9
9.2 Restoring factory settings
9.3 Firmware Upgrade
Restoring factory settings can restore the device to its initial state, including all settings in the network, encoding, decoding, and system.
Note: The firmware version will not be restored. The factory default IP address of the device is: 192.168.1.188.
The company’s official website will regularly release new upgrade firmware, and users can download the latest firmware to upgrade as
needed. Download address: " http://www.science-image.com", After downloading, you can click the[Open Upgrade Page] button on the
[System] page to enter the upgrade page or click the human icon in the upper right corner and then click the [Firmware Upgrade Upgrade]
button.
After entering the upgrade page, click the [Select File] button at ①, select the firmware to be upgraded, such as: siup-ndi-20201220b.si, open it,
and there will be a progress prompt in the lower left corner of the browser.When finished, the uploaded file information will be displayed.
The button at ② will also change from
red
to
green,
and then click to start the upgrade. As shown below:
When the progress bar reaches 10%, there will be a long pause.
Don’t be surprised, just wait patiently.
ion.
Attention:
1
2
After the progress bar reaches 100%, click the pop-up [Finish] button and close the upgrade page to complete the upgrade
operation. After confirming that the upgrade is successful, power on and restart the device.
Do not cut off the power during the upgrade process, otherwise the system files
may be damaged and the system will not start normally.
Note:
