SciCan STATIM 900J, Operator'S Manual, Page: 10 / 31

STATIM
900J Operator’s Manual
10
4.1 Using The Sterilization Chamber Drawer
The Statim 900J keypad has four buttons.
The first three buttons will initiate one
of the three different sterilization cycles.
These cycles are described in detail
in section 4.4 Selecting A Cycle. The
fourth button on the keypad, the
MULTIFUNCTION button, opens and
closes the Sterilization Chamber Drawer.
• To open the Sterilization Chamber Drawer
:
1. Press the MULTIFUNCTION button and the drawer will open automatically.
2. Lift the instrument basket from the sterilization chamber.
3. Load instruments to be sterilized into the instrument basket. Ensure you
follow the instrument manufacturer’s reprocessing instructions to ensure you
do not damage the instruments.
4. Replace the instrument basket into the sterilization chamber.
5. Press the MULTIFUNCTION button and the drawer will close automatically,
or press one of the sterilization cycle buttons and the drawer will close and
the selected sterilization cycle will begin automatically.
• To Remove The Sterilization Chamber Drawer
:
To remove the sterilization chamber drawer, follow these steps:
1. Open the drawer by pressing the
MULTIFUNCTION button on
the keypad.
2. Turn the unit power switch to OFF.
3. Locate the green latch inside the
front opening of the machine near the
top right hand side. Push the latch to the
right and gently pull the drawer out of the unit.
Be careful. The instruments and the metal parts of the drawer may be hot.
• To Replace The Sterilization Drawer
:
To replace the sterilization chamber drawer, follow these steps:
1. Center the drawer into the opening.
2. Rest the rear ends of the drawer on the front rollers in the opening.
3. Tilt the front of the drawer upwards and push the drawer into the unit. Level
the drawer and continue to push until the drawer clicks into the intermediate
position. Lift and push the drawer past the position where the green latch is
engaged by the drawer.
4. If installed properly, the drawer cannot be removed without pushing
the green latch.
5. Turn the power ON and close the drawer by pressing the MULTIFUNCTION
button.
Rubber
& Plastic
Cycle
Handpieces /
Hollow
Instrument
Cycle
Solid
Instrument
Cycle
4. Instructions for Use