Schwinn 130i Upright Bike, Assembly Manual / Owner'S Manual

Page: 34 / 36

34
Condition/Problem Things to Check Solution
Check data cable
connections/orientation Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Reset Machine Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Check magnet position
(requires shroud removal) Magnet should be in place on pulley.
Check Speed Sensor
(requires shroud removal) Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Unit rocks/does not sit
level Check leveler adjustment Adjust levelers until bike is level.
Check surface under unit Adjustment may not be able to compensate for extremely uneven
surfaces. Move bike to level area.
Pedals loose/unit difficult
to pedal Check pedal to crank arm
connection Pedal should be tightened securely to crank. Insure connection is
not cross-threaded.
Clicking sound when
pedaling Check pedal to crank arm
connection Remove pedals and reattach.
Seat post movement Check locking pin Be sure adjustment pin is locked into one of the seat post adjust-
ment holes.
Check adjustment knob Be sure knob is securely tightened.