ENGLISH
SM-54
- 16 -
8 Problem Solving
Problem
Reason
Removal
Transfer press does not work after
pushing the start button
1. Compressed air pipe is not
connected.
Connect the compressed air pipe with the
compressed air filter (Ch. 3)
2. Compressor is turned off
Turn on the compressor
3. Pressure regulator is closed
Turn the pressure regulator to the left
(Ch. 4.2)
4. Sliding table is not in end
position
Push the sliding table until it blocks
(Ch.5)
5. Start buttons didn’t get pushed at
the same time
Push the start buttons both at the same
time (Ch. 5)
6. Pushed emergency stop
Open the emergency stop
After the printing process started,
the heat element lowers but returns
immediately into is original
position.
Work plate was set up to low/ the
gap between heat element and
work plate is too big.
Raise the work plate, clearance max. 25
mm (Ch. 4.1)
Work plate is twisting
Height
is
not
adjusted
or
insufficient locked in place.
Arrange the work plate and lock the right
height adjustment through turning the clip
handle to the right - until the work plate is
not twistable anymore. (Ch. 4.1)
