4
Spring
Spring
holder
8
CHANGING TEFLON FOIL
2
Heavy
Disconnect heat press from electricity!
2
1
M8-screw
M5-screw
Side
covering
3
Handle
Heavy
- 15 -
Disconnect heat press from electricity!
First of all disconnect the press from
electricity!
Should you change the Teflon foil during
operation bear in mind that the hot Teflon
foil and the fixing material are hot.
That is why you must wear heat-proof
gloves.
1
Loosen the three M5 screws on the left and right
side covering by turning them half a circle or a
full circle. Remove the four M8 screws on both
sides.
2
Remove both side coverings. To do so tilt the
side coverings into your direction and lift them
carefully together with a second person until the
bottom edge is free.
3
Push a base plate into the heat press. Pull the
handle upwards in a diagonal direction, then
move it downwards and place the whole Teflon
foil on the base plate.
4
Pull the two springs from the spring holders on
the opposite side. Now the Teflon foil lies on
the base plate. Pull the base plate out of the heat
press.
5
Remove the springs and pull the tensioning rods
out of the eyelets of the Teflon foil.
6
Exchange the Teflon foil for a new one and
follow the instructions in the opposite direction
to build it in.
5
Dismounted
Teflon foil
Tensioning rod
