SCHUNK WSG 25, Assembly And Operating Manual

Page: 26 / 56

Start-up
26
05.00 | WSG 25 | Assembly and Operating Manual | en | 389684
6 Start-up
6.1 Initial commissioning
NOTE
To ensure fault-free operation and to minimize the radiation of
electromagnetic interference (EMC) the product’s housing must
be properly earthed.
When starting up the product for the first time, please follow the
steps below:
Ø
Using the Ethernet/Power cable, connect the product to the
existing Ethernet network of alternatively to the network card
in your PC or laptop.
NOTE
• The product’s IP address is factory-set to a static value of
192.168.1.20. Should you wish to operate several products in
the same network and/or if this address is already in use, then
you will have to change the product’s IP address accordingly
(e.g. set the 2nd product’s IP address to 192.168.1.21). To do
that, first connect the product directly to computer’s network
connection, to avoid address conflicts in the network. For more
information about changing the IP address:
Changing the IP
address and using DHCP [
}
29]
• To directly operate the product on your computer’s network
connection, you may have to alter your computer’s network
configuration. If in doubt, contact your system administrator.