SCHUNK STM 560V Series, Assembly And Operating Manual

Page: 32 / 72

Start-up
32 04/STM-560V/en/2010-12-10/SW
8 Start-up
NOTICE
Malfunction in the event of an overload!
 Avoid impact loads.
 Do not exceed the bearing load limits.
NOTICE
Malfunction in the event of overheating!
 Observe the motor’s technical data.
(see chapter 6.1, page 19)
WARNING
Risk of injury and material damage when the
machine/system moves unexpectedly
 Only allow configuration work to be carried out by authorized
specialist personnel.
 Observe the information in the operating manual for the
controller.
WARNING
Collisions in setup mode when the machine/system moves
unexpectedly
 Keep the motor's moving range (360°) free.
 Connect the electrical connections (power cable, signal cable)
to the converter.
 Check that the rotor can be turned freely. In doing so, pay
attention to any grinding noise.
 Check that all required contact protection measures were
taken for moving and live parts.
1. Switch on the converter and start the commissioning
software.
Starting up
the STM with an
arbitrary converter