Basic safety notes
10
02.00|ROTA NCA |en
•
The maximum recommended speed may only be operated in
conjunction with maximum actuating force and only with the
lathe chuck in optimum, fully functioning condition.
•
After a collision, the lathe chuck and the chuck jaws must be
subjected to a crack test before being used again. Damaged
parts must be replaced with original SCHUNK spare parts.
•
Renew the chuck jaw mounting screws if there are signs of
wear or damage. Only use screws with a quality of 12.9.
•
Screw the jaw mounting screws into the bore holes furthest
apart.
Environmental and operating conditions
Required ambient conditions and operating conditions
Incorrect ambient and operating conditions can make the product
unsafe, leading to the risk of serious injuries, considerable material
damage and/or a significant reduction to the product's life span.
•
Make sure that the product is used only in the context of its
defined application parameters,
•
Make sure that the product is a sufficient size for the
application.
•
Only use high-quality cooling emulsions with anti-corrosive
additives during processing.
Clamping force measurement
Depending on the operating conditions, the function and clamping
force must be checked after a certain period of operation
With the smallest possible actuating pressure (hydraulic cylinder),
the base jaws should move evenly. This method only provides a
limited indication and is not a substitute for measuring the
clamping force.
2.6
