SCHUNK KSP plus-BWM Series, Assembly And Operating Manual

Page: 6 / 55

General
6 04.00|1151449 KSPplus-BWM, KSP-LHplus-BWM |en
Applicable documents
• General terms of business *
• Catalog data sheet of the purchased product *
The documents marked with an asterisk (*) can be downloaded on
our homepage schunk.com
Sizes
This operating manual applies to the following sizes:
• KSP plus-BWM 100, 160, 250
• KSP-LH plus-BWM 100, 160, 250
Warranty
The warranty period is 24 months after delivery date from factory
or 500 000 cycles*, if it is used as intended, under the following
conditions:
• Observe the applicable documents, (

1.1.2, Page 6)
• Observe the ambient conditions and operating conditions,
(

2.6, Page 8)
• Observance of the specified care and maintenance instructions
(

8, Page 36)
Parts touching the workpiece and wear parts are not included in
the warranty.
* A cycle consists of a complete clamping process ("Open" and
"Close").
Scope of delivery
KSP plus-BWM or KSP-LH plus-BWM clamping block
(without changing jaws, reversible gripping inserts and clamping
bars)
ACCESSORY PACK:
(for contents, see chapter accessory packs
(

9.2, Page 43) )
Accessories
(see catalog or data sheets when ordering separately)
Changing jaw type: WTR, WTG (see chapter "WTR, WTG changing
jaws" (

5.2, Page 19) )
Reversible gripping inserts for WTR, WTG
Clamping bars for WTR, WTG
TANDEM base plates
Valves, pneumatic screws
Hexagonal socket screwdriver
1.1.2
1.1.3
1.2
1.3
1.4