_________________________________________________________________________________________
schunk.com
XND.00033.002_A – 10/2018
35
8
Assembly
Installing the carriage unit
Fully contract the carriage unit.
Push the carriage unit into the guide until it comes into contact with the other component.
The carriage unit is now positioned around 20 mm over the centre. Important: carriage
unit must not come into contact with the rear cylinder screw. (pos. 160)
Fully tighten the clamping screw (pos. 230) and undo by ½ turn.
Extend the carriage unit and check whether or not the cylinder screw (pos. 40) and the
clamping screw (pos. 230) have correctly engaged in the clamping piece. (pos. 220).
Install the front cylinder screw. (pos. 160)
Install the system jaws.
