9
3.6 Back unit adjustment
The complete back unit can be adjusted in the
depth of the seat pan / seat unit. Remove the 4
screws (arrows) on the right and left of the top
frame, slide the back unit out or in and insert the
screws again and tighten.
3.8 Push bar
The design with the push handle is a more com-
fortable solution. The angle of the push handle
can be individually adjusted in addition to height
adjustment using the joints with quick release (B).
The height is adjusted after loosening the two
clamp levers (C) on the rear tubes. The clamp
lever and quick release must be tightened again
after each adjustment.
B
B
C
C
The following are general rules:
Higher air pressure:
Low rolling resistance / less suspension comfort
Lower air pressure:
Higher rolling resistance / more suspension comfort
See point 9 for sizes and air pressure for the guide and rear wheels (technical data).
4. Handling wheels
3.7 Push handles
The height of push handles can be individually
adjusted on your FLOYD. This takes place after
loosening the two clamp levers (A) on the rear
pipes.
The clamp lever must be tightened again after
each adjustment.
A
A
