• 4 •
•
Do not modify the AC or USB receptacle in any way.
•
Do not try extending or otherwise changing the 12 volt power cord attached to
your converter.
•
Incorrect operation of your converter may result in damage and personal injury.
•
This device does not include an internal Ground Fault Circuit Interrupter
(GFCI). For GFCI protection, use a Coleman Cable 02822 GFCI outlet.
PERSONAL SAFETY PRECAUTIONS
•
Wear complete eye and protective clothing when working near lead-acid
batteries. Always have someone nearby for help.
•
Remove all personal metal items from your body, such as rings, bracelets,
necklaces and watches. A lead-acid battery can produce a short circuit current
high enough to weld a ring to metal, causing a severe burn.
•
Never smoke or allow a spark or flame in the vicinity of the battery or engine.
BEFORE USING YOUR CONVERTER
•
This converter is designed to be used with a single battery, up to group 31
(130 Ah or smaller). The recommended source of power is a 12 volt deep-
cycle battery, due to their high reserve capacity. Automotive batteries are
recommended for only a short period of time of an hour or less.
•
Do not use the converter with a product that draws a higher wattage than the
converter can provide, as this may cause damage to the converter and product.
When you turn on a device or a tool that runs on a motor, the device goes through
two stages:
1. Start Up –
Requiring an initial surge of power (commonly known as the
“starting” or “peak” load).
2. Continuous Operation –
Power consumption drops (commonly known as
the “continuous load”).
The wattage (WATTS) or amperes (AMPS) can normally be found stamped or
printed on most devices and equipment, or in the user’s manual. Otherwise,
contact the manufacturer to find out whether the device you want to use is
compatible with a modified sine wave.
To calculate the wattage: Wattage = AMPS x 120 (AC Voltage).
To calculate the starting load: Starting Load = 2 x wattage.
In general, the startup load of the device or power tool determines whether your
converter has the capability to power it.
Always run a test to establish whether the converter will operate a particular
piece of equipment or device. In the event of a power overload, the converter is
designed to automatically shut down.
This safety feature prevents damaging the converter while testing devices and
equipment within the wattage range of the converter.
Summary of Contents for XI41B
Page 22: ...22...
