• 13 •
15. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
All five LEDs come on
for 2 seconds, then
turn off.
The charger is plugged into
an AC outlet.
No problem; this is normal.
I cannot select a 6V or
12V setting.
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
No problem; this is normal.
The green POWER
LED does not light
when charger is
properly connected.
AC outlet is dead.
Poor electrical connection.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and
extension cord for a loose
fitting plug.
The red
BAD
BATTERY LED is lit
and yellow/orange
LED is flashing.
The battery voltage is
still below 10V (for a 12V
battery) or 5V (for a 6V
battery) after 2 hours of
charging.
(or)
In maintain mode, the output
current is more than 1.5A for
12 hours.
The battery may be defective.
Make sure there are no
loads on the battery. If there
are, remove them. If there
are none, have the battery
checked or replaced.
Summary of Contents for SPI1
Page 18: ...18...
