• 7 •
7.3
Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.
7.4
Position yourself and free end of cable as far away from battery as possible – then connect NEGATIVE
(BLACK) charger clip to free end of cable.
7.5
Do not face battery when making final connection.
7.6
When disconnecting charger, always do so in reverse sequence of connecting procedure and break first
connection while as far away from battery as practical.
7.7
A marine (boat) battery must be removed and charged on shore. To charge it on board requires
equipment specially designed for marine use.
8. GROUNDING AND AC POWER CORD CONNECTIONS
8.1
This battery charger is for use on a nominal 120 volt circuit and has a grounded plug. The charger must be
grounded, to reduce the risk of electric shock. The plug must be plugged into an outlet that is properly installed
and grounded in accordance with all local codes and ordinances. The plug pins must fit the receptacle (outlet).
Do not use with an ungrounded system.
8.2
DANGER: Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper grounded
outlet installed by a qualified electrician. An improper connection can result in a risk of an electric shock
or electrocution.
NOTE: Pursuant to Canadian Regulations, use of an adapter plug is not allowed in Canada. Use of an
adapter plug in the United States is not recommended and should not be used.
8.3
USING AN EXTENSION CORD
The use of an extension cord is not recommended. If you must use an extension cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger, as specified:
Length of cord (feet)
25
50
100 150
AWG* size of cord
16
12
10
8
*AWG-American Wire Gauge
9. ASSEMBLY INSTRUCTIONS
9.1
Remove all cord wraps and uncoil the cables prior to using the battery charger.
10. CONTROL PANEL
ON/OFF SWITCH
Use this switch to select between the Charge/Maintain rate, Boost rate and the Engine Start mode.
OFF – When the switch is in this position (middle), the charger is turned off.
BOOST or CHARGE/MAINTAIN – When the switch is in this position, the Rate Selection button can be
set to either the 2<>6A Charge/Maintain or the Boost setting.
ENGINE START – When the switch is in this position, the Engine Start LED will be on.
DIGITAL DISPLAY
The Digital Display gives a digital indication of amperage, voltage or % of charge. If you manually stop the
charging process (by pressing the START/STOP button), the display will show OFF.
NOTE: During charging, the display could go into sleep mode and will not show the amperage, percentage
of charge or voltage of the battery. To turn the display back on, press the Display button. Keep pressing the
display button to turn off the display and save energy.
DISPLAY BUTTON
Use this button to set the function of the digital display to one of the following:
Battery % – The Digital Display shows an estimated charge percentage of the battery connected to the
charger’s battery clamps, when charging. When the starting battery voltage is below 8.0V, the battery
percentage is not yet available and will show “----“
Amps – The display will show the approximate charging current.
Voltage – The Digital Display shows the voltage at the charger battery clamps, in DC volts.
