Schulthess Spirit eMotion TW 7335i, Instructions For The Use

Page: 62 / 68

62
X Rub your hand over the filter and remove the fluff.
It may happen that a supposedly proper cleaned fil -
ter becomes impermeable, due to a fine, invisible coat
remaining in the filter meshes.
X
Hold the filter with one flat surface up wards and pour
a little water on to it. If it is impermeable, clean the filter
with a brush under running water.

If the coat cannot be brushed away, a commercial
descaler spray must be used to dissolve it.
X
Spray the descaler on the entire filter surface and
leave it to take effect. In case of stubborn coats place
one layer
of kitchen roll onto the filter surface and spray
descaler on it to ensure the filter is moist. Leave the
descaler to take effect overnight. Then clean the filter
under running water with a fine brush.
Cleaning the filter B / Clean daily
The outer coarse filter ( B ) must be removed and cleaned
every day.
The outer coarse filter ( B ) must only be removed and
cleaned once a week.
Switching off the machine
X
Close the door.
X Switch the machine off at the wall.
 If there is not wall switch, the display field will auto -
matically go out, and the dryer will switch to OFF mode
(see chapter «sExtended basic settings/ Standby func-
tion»).
Basic Settings
The machine has basic settings from the factory. It can
be adapted to the user's individual needs either when
first used or later using the following functions.
The basic settings can only be changed if no dry pro-
gramme is running. To change a basic setting, it is first
necessary to hold the programme button pressed and
then press the fast forward button. The corresponding
function is shown on the digital display. The display
changes when the fast forward button
is pressed
repeatedly with the programme button held down.
Example:
Function switched off
Function switched on
Initial dampness (ex factory
50%
)
+
The accuracy of the time remaining is increased if the
dryer is adjusted to the spin speed of your washing
machine.
Spin speed 1600 rpm - 50% residual moisture
Spin speed 1200 rpm - 60% residual moisture
Drying level (ex factory
NORMAL
)
+
If the drying level is set to «Higher», with the moisture
controlled programmes «Cabinet dry» and «Extra dry»
the laundry will be slightly drier.
Crease protection (ex factory
30MIN
)
+
When this function is switched on, a crease protection
phase of max. 60 minutes begins at the end of the pro-
gramme.
Time (the time is not set ex factory)
+
The hours can be set using the button and the
minutes using the button.