SCHOLTES TI 6533/HA, Operating Instructions Manual

Page: 13 / 52

GB
13
H
h Top = 30mm h Top = 40mm
23 mm 13 mm
Connecting the hob
• The electrical safety of this appliance can only be
guaranteed if the latter is correctly and efficiently
earthed, in compliance with regulations on
electrical safety. Always ensure that this vital
safety measure has been taken. If you have any
doubts, call in a qualified technician to check the
electrical system thoroughly.
• The manufacturer denies all responsibility for
damage resulting from a system which has not
been earthed correctly.
• Before powering the appliance, check whether the
technical characteristics featured on the appliance
data plate correspond with those of the mains
electrical system.
• Check that the current load of the mains supply
and of the power sockets is suitable for the
maximum power of the appliance, indicated on
the appliance data plate. If in doubt, contact a
qualified professional.
Disconnect the appliance from the electricity
supply before all operations.
Connect your hob to the electrical system by means
of a junction box:
junction box:
junction box: junction box: junction box: if the appliance is connected
permanently to the mains, an omnipolar circuit
omnipolar circuit
omnipolar circuit omnipolar circuit omnipolar circuit
breaker breaker breaker breaker breaker, accessible if necessary, with a minimum
contact opening of 3 mm should be installed.
Valid only for models with a power supply cable
Some models are supplied with a single-phase power
supply cable, and should consequently only be
connected to the single-phase mains. Observe the
wire colours, as indicated in the diagram attached.
Valid only for models without a power supply cable
Some models are not fitted with a power supply cable,
as the cable should be sized according to the type of
electrical connection in use (see connection table
below). To connect the cable, proceed as follows:
1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
( see diagram ).
2. Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
(see figure).
3. Remove the wire
contact screws L-N-
, then fasten the wires
under the screw heads,
respecting the colour
code: Blue (N), Brown
(L) and Yellow-Green
Verde ( ).
• to make the desired electrical connection (see
table), use the jumpers housed inside the box.
Position the power supply cable wires according
to the indications in the table.
• once the connections have been made, tighten all
the terminal screws fully.
• Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
Electrical connections Voltage, Frequency Fuses, Sections
FR-BE-AT-DE-GR-ES-IL-
IT-NZ-PT-GP-CH-MA-LU-
IE-FI-SE-IS-GB-NL-DK
230V - 1+N~ 50Hz
CY-MT-AU-NZ-KW
240V - 1+N~ 50Hz
25A *
2,5 mm²
FR-BE-NO
230V - 2 ~ 50Hz
BR=BRUN,BL=BLEU
BR=BRUIN, BL=BLAUW BR=BRAUN, BL=BLAU
BR=BROWN, BL=BLUE
* Application of the simultaneity coefficient in accordance with
cei 60335-2-6 norm
BL
N
BR
L
BL
N
BR
L