4 Maintenance and servicing
16
SCHMIDT
®
ElectricPress 343-345
– V2.1
4 Maintenance and servicing
CAUTION
Safety instructions
The press must only be serviced by a skilled person.
Any work on the electrical equipment of the press must be carried out
only by trained electricians or by specially instructed persons under the
control and supervision of a trained electrician and in accordance with
the applicable electrical engineering rules and regulations.
All spare parts must comply with the technical requirements specified
by SCHMIDT Technology. This is always guaranteed in the case of
original spare parts.
Unless expressly described otherwise, do not start with the maintenance and
servicing work until
the press has been disconnected from the power supply,
the press has been switched off and secured against restart,
the dangerous movements have been stopped,
and unauthorized, unintentional or inadvertent starting of dangerous
movements which may be caused by saved energy is avoided.
Interval
Activity
Every week
(every 50 operating hours)
see chapter "4.1 Cleaning the press and the ram"
Every year
(every 3,000 operating hours)
see chapter "4.2 Adjusting the force measurement"
Automatically
(suggested by the control)
see chapter "4.3 Lubricating the gear"
After a malfunction
see chapter "4.4 Checking ram extension"
Further information about the necessary activities you get in the individual
chapters.
4.1 Cleaning the press and the ram
CAUTION
In any case do not use any solvent based cleaners.
Clean the press with a lightly oiled cloth.
Move the ram to the BDC position.
Clean the ram with a lightly oiled cloth.
Maintenance intervals
Press
Ram
