3 Assembly and start-up
8
SCHMIDT
®
ElectricPress 343-345
– V2.1
3 Assembly and start-up
CAUTION
Safety instructions
The press must only be installed and put into operation by a skilled
person.
Any work on the electrical equipment of the press must be carried out
only by trained electricians or by specially instructed persons under the
control and supervision of a trained electrician and in accordance with
the applicable electrical engineering rules and regulations.
Observe the dimensions, weights and setting values listed in the
manual or the data sheets.
Check the press, accessories and all supply lines for possible damage
prior to each start-up.
Switch off a defective press immediately and have the disturbances
repaired as soon as possible.
Improper transport, installation and commissioning is prone to accidents and
can cause damage or malfunctions to the delivered components for which
SCHMIDT Technology does not grant any liability or guarantee.
3.1 Delivery
Check the delivered components for visible transport damage.
Report any transport damage immediately to the following authorities:
the carrier
the dispatch department of SCHMIDT Technology
Packing
Keep the original packaging and transport aids, if present, for later
transports and/or for further storage.
3.2 Transport
Short internal transport distances reduce the risk of accidents.
Use sufficiently dimensioned transport equipment.
During transport, ensure that the component(s) are handled properly.
The components may only be transported on a suitable stable base (e.g.
pallet).
Do not lift the press at the tool magazine area or at mounted parts.
Secure loose parts accordingly before transport.
